Q-See QSC26416 Bedienungsanleitung PDF herunterladen (Seite 87)

User Manual for Commercial Series Net DVR

Page 87 Total 121

6.16 RS232 setup

There is one RS-232 port on DVR rear panel. In main menu, move “Active Frame” to

“RS232” icon and perss【ENTER】key, you enter into “RS232” setup menu:

RS232 menu description

RS-232 parameters: Including baud rate, data bit, stop bit, parity, flow control, etc.

Work mode: The RS-232 can be used as “Console”, “PPP” or “Transparent Channel”.

Console: Connect with PC serial port. You can use HyperTerminal or NetTerm to control it.

PPP: Connect Modem, using PSTN to transfer video image.

Transparent channel: Connect serial devices. Remote PC can control these serial devices

through network.

PPP Mode: Only used when work mode is “PPP”. There are two options: “Active” and

“Passive”. “Active” means DVR will diaup through PSTN. “Active” function is not available.

“Passive” means DVR will wait for dialup.

Callback mode: Only used when work mode is “PPP”. There are two options: “By Dialer”

and “Preset Tel’. This function is not currently available.

Remote IP: Only used when work mode is “PPP”. This IP is defined for remote PC that will

connect DVR through PSTN.

Local IP: Only used when work mode is “PPP”. This IP is defined for DVR.

Mask: Only used when work mode is “PPP”. Remote IP and Local IP are in the same sub

net.

Username, password and Verify password: Only used when work mode is “PPP”. Used for

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 120 121

Keine Kommentare

Q-See QSC26416 Bedienungsanleitung Seite 87