Q-See QSPDVR04 Bedienungsanleitung PDF herunterladen (Seite 41)

Error! Use the Home tab to apply

1 to the text that you want to

appear here. Error! Use the Home

tab to apply 1 to the text that

you want to appear here.

4.5.3 Alarm Output

Figure4-11 Alarm Output Configuration

Press in the main interface and access to the following Alarm

Configuration area where users can make a setup for motion detection alarm,

sensor alarm setup and short of HDD space alarm setup.

1. Video Loss

Users can select alarm output for this option. For example, users select

alarm_out1 and alarm_out3 for video loss. Then video loss of any channel will

trigger alarm_out1, alarm_out3 to show red light in the Alarm output status

panel (refer to Figure3-6 for reference).

2. Disk Alarm

When HDD available space is less than the set value (see Figure4-9), it will

trigger alarm.

3. Sensor

Sensor 1: If users have mounted sensors, when the sensors have been

activated, then it will trigger the selected output alarms.

Sensor 2 - Sensor 16: TwoTD4116 cards have maximum 16 sensors.

4. Motion

Motion 1: Users can set the output of motion detection alarm by different

alarms and remote alarm.

Motion 2 - Motion 16: 32CH card has maximum 16 motion alarms.

NOTICE

You should choose our additional alarm device board while using twoTD4116 cards for

alarm I/O.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 100 101

Keine Kommentare

Q-See QSPDVR04 Bedienungsanleitung Seite 41