Q-See QSPDVR04 Bedienungsanleitung PDF herunterladen (Seite 82)

Error! Use the Home tab to apply

1 to the text that you want to

appear here. Error! Use the Home

tab to apply 1 to the text that

you want to appear here.

Users should firstly enable the P.T.Z control function of certain camera and

select a port number in P.T.Z Protocol Setup (refer to Fig7-26), and then set

corresponding parameters in the area below:

Fig 7.27 P.T.Z Serial port setup

A. Port

Users can set port number

B.Baud rate

Set P.T.Z device Baud rate, default value is 9600

C.Data bits

Default value is 8

D.Parity

Odd and even parity bit, default Null

E.Stop bits

Default value is 1

Notice: Users should look into the P.T.Z device and get Baud rate,

Protocol and Address firstly, and then set other values accordingly.

If click , users could copy the setting of this channel to any other

selected channel.

7.5 Mobile Surveillance

7.5.1 Introduction to Mobile Surveillance

In MAXDVR system, the mobile surveillance can be realized by connecting

the mobile phone to the system. For time being, the function is supported by

Windows Mobile system and Symbian Series 60 Developer Platform 2.0

intelligent mobile phone system.

So far, the types of phones on which the function has been tested are shown

as below table.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 100 101

Keine Kommentare

Q-See QSPDVR04 Bedienungsanleitung Seite 82