Q-See QC3016 Wartungshandbuch PDF herunterladen (Seite 33)

64 65

PICTURE 4-17

PICTURE 4-18

4.4 ADVANCED

The settings in this menu cover user accounts, hard disk management, video display, and

system maintenance.

CAUTION! Reformatting the hard drive will erase all recorded events.

HDD MANAGE

This displays some of the same information found in the HDD Info window in the Info menu

(see Section 4.2) but this window allows you to make additional settings.

The drive name and status is displayed.

The status indicators are:

Clicking on Alarm Set opens the Abnormality window which is covered immediately

following this section.

Alarm Release – this turns off any disk alarm that may be occurring.

You can set the hard drive to four states:

O Drive is operating normally.

X Indicates an error

- Hard drive not installed

? Hard drive is damaged

Read/Write

Normal operation. The device records (writes) ﬁles to disk and plays (reads)

them.

Read Only No more ﬁles can be recorded onto the drive, but existing ﬁles can be viewed.

Format Reformats the hard drive.

Recover

If you are having problems with the hard drive, including corrupted ﬁles,

selecting Recover causes the drive to re-set, but does not erase its contents.

No changes will take place unless the Execute button is pressed once you’ve made your

selection. The drive’s status will be displayed next to the Type heading below the pull-downs.

If you make changes and press Execute, the DVR will restart once you press OK to exit. You

cannot right-click out of the menu.

ERROR ALERTS

This window allows you to set up alarms for disk and system disconnection errors as well as

how these alarms are handled. Each type of alarm can be independently enabled along with

what events that type of alarm will trigger.

ERROR ALERTS

Event Type

Enable

Show Message Alarm upload Send Email

Buzzer

No Disk

Save Cancel

Event type – Chose from No Disk, Disk Error,

Disk No Space, Net Disconnected

and IP Conﬂict.

Show Message – When enabled, this will

display the event notiﬁcation on the

DVR’s screen.

Alarm Upload – This feature is not available

on this model.

PICTURE 4-19

Send E-mail – this will send an e-mail notiﬁcation to the recipient address set up in the

Network menu (see Section 1.2 Advanced Network Setup in the Remote

Monitoring Guide).

RECORD SETTING

This is the Manual Recording window covered in Section 3.4.

ACCOUNT

This is the account management window which allows you to add or delete users, create user

groups, modify the access privileges of users, and create or change passwords.

There are two pre-conﬁgured default

users; Admin, and 666666. Only Admin has

administrator rights.

When adding a user, you not only create their

user name and password, but you can grant

or deny control over speciﬁc activities on the

DVR, including which cameras that user can

view or play back. These privileges can be

changed later by an administrator-level user

using the Modify User button. Administrator

Users have control over 60 different functions

while basic Users have 35 functions that can

be allowed or denied.

PICTURE 4-20

A user or group name can consist of at most eight characters and no two users may have the

same user name. There is no limit to the number of users or groups.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 44 45

Kommentare zu diesen Handbüchern

Keine Kommentare

Q-See QC3016 Wartungshandbuch Seite 33

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Videorecorder (DVR) Q-See QC3016