Q-See QT528 Bedienungsanleitung PDF herunterladen (Seite 13)

24 25

CHAPTER 4 MAIN MENU SETUP

ALARM OUT

Set how the alarms are handled and transmitted in this window. This controls any device

attached to the ALARM OUT port on the back of the DVR. There are three tabs; Alarm Out,

Schedule and Buzzer.

Alarm Out Tab

You can set the relay alarm out name as well as the hold time. Hold time is the interval

between consecutive alarm activations so multiple events within the interval will not cause the

alarm to sound again.

Schedule Tab

The default setting is for the ALARM OUT to be active all the time, but this can be changed

to meet your particular requirements in a similar manner to Schedule in SECTION 4.4.

Buzzer Tab

As with the Alarm Out hold time, the internal buzzer can be enabled and given a hold time.

PICTURE 4-34

4.6 NETWORK CONFIGURATION

This section covers setting up your DVR so that it can be remotely monitored from another

computer on your network, over the Internet or from mobile wireless devices. E-mail alerts

are also conﬁgured here and you can set up a DDNS service for a more reliable connection

to your remote devices (See Section 7.4 DDNS for more information). The four tabs in this

window are Network, Sub-Stream, Email and Other Settings. If you will only be monitoring

the DVR from another computer on your network, you will only need to use the ﬁrst three tabs.

It is important that your DVR is connected to your network router and that the router is

powered on before proceeding.

PICTURE 4-35

Network Tab

HTTP Port – This is the port the DVR will

occupy on your computer network

(See Section 7.3 Port Forwarding

for more information). When

accessing the DVR remotely from the

Internet, you will need to enter your

network’s Public IP address (obtained

in the next step) in the address bar

of an Internet Explorer window. For

example: http://76.254.183.54

Obtain IP Address Automatically – Clicking this box will obtain the IP address, subnet mask,

and gateway IP from the router.

PPPOE – Selecting this enables Point-to-Point Protocol over Ethernet (PPPoE) which allows

you to directly connect your DVR to the Internet through your modem. Do not use this

unless required by your Internet Service Provider (ISP) or if you are already connected

to a router. Contact your ISP for your account information including user name and

password. The TEST button will verify that your information is correct.

NOTE! The default value is 80. If port 80 is already occupied by another device

on the network, then another port will need to be selected. Choose another

number in the same range; 81-89. In this case, you will have to add the port to

the IP address when entering it into the Internet Explorer window. For example,

if the port is now 82, then you will need to enter http://76.254.183.54:82

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare

Q-See QT528 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Videorecorder (DVR) Q-See QT528