Q-See QT528 Bedienungsanleitung PDF herunterladen (Seite 24)

46 47

CHAPTER 7 REMOTE SURVEILLANCE

STEP 8. To ﬁnish the IP address, you will need to enter a fourth set of numbers that

is different than any other device attached to the same router. If the fourth set of

numbers in your IP4v address is a single or double-digit number, then you can enter

any three-digit number up to 254. If, on the other hand, the IP4v address ended with a

number in the 100s, then enter a number between 200 and 254.

STEP 9. Click the Test button (Red box in Picture 7-9) to verify that your settings avoid

conﬂict.

A. If you get the OK message in the lower left corner of your screen, you may click on

the Apply button before closing the window.

B. If you get a failure message then try a different three-digit number for the IP

address.

IMPORTANT! Do not use 255 or higher to complete your IP address as these

addresses are reserved for other devices and components.

PPOE

If you are going to attach the DVR directly to a DSL or cable modem instead of to a router

then select the PPPOE option in the Network options. Before you proceed, you will need to

contact your ISP to obtain your User Name and Password.

STEP 1. Select the Setup icon in the

Main Menu (Red Box in Picture

7-10)

STEP 2. Select the Network icon (Red

box in Picture 7-11)

STEP 3. Check the box next to PPPoE

Red Box in Picture 7-12)

STEP 4. Enter the User Name and

Password obtained from your ISP in

the ﬁelds below PPPoE

STEP 5. Click the Test button to verify

your settings.

STEP 6. After receiving the OK message

in the lower left of your screen, click

on the Apply button to save your

settings before exiting.

PICTURE 7-10

PICTURE 7-11

PICTURE 7-12

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 49 50

Keine Kommentare

Q-See QT528 Bedienungsanleitung Seite 24